Lithofin Muro Cement Remover

Lithofin Muro Cement Remover for Cleaning

Cement smears are the grout lines that remain on your floor tiles after installation. During installation, the tiler applies the grout, spreading it evenly across the entire surface with a sponge.

Sometimes invisible, cement residue causes numerous maintenance problems because it never disappears until a product is applied to permanently remove the cement film. It is mandatory to apply a stripping treatment with Lithofin Muro after any tiling and grouting.

This product is not a maintenance product and should only be applied two or three times maximum. After that, you should continue with a product like Lithofin Glastilan.

The strength of Lithofin Muro is to eliminate and dissolve surface dirt such as: mortar residues, cement veils, efflorescence, hardened dirt deposits, limescale and rust deposits.

We recommend using it for final cleaning after tiling , natural or artificial stone, and terracotta. Lithofin Muro is particularly suitable for outdoor use and construction sites.

The product cleans all acid-resistant coatings, such as ceramic tiles, extruded stoneware tiles, brick surfaces, terracotta, rough artificial stone surfaces, concrete, and many natural stones.

This post-installation tile cleaner is not suitable for polished limestone surfaces (marble, artificial stone). For polished and rough artificial stone and limestone surfaces, the product must be diluted in a 1:20 ratio.

Technical description

• - Use: cleaning
• - Surface: indoor floor, outdoor floor
• - Packaging: 1L
• - Yield: approximately 30 to 50m² / L depending on the type and extent of soiling.

Good to know:
If you have areas of more than 50 m², you should therefore use one container for every 10 L of water.